Panasonic PAW280MAH2 Instrucciones de operaciones descargar pdf (Pagina 71)

Control

3. On the CZ-CAPBC2 PCB, cut jumper “JP1”, in order to activate the 0–10 V demand control

mode for the external BMS. Make sure that all other jumpers remain intact.

4. On the CZ-CAPBC2 PCB, set switch S3 to “VOLTAGE” or “NO VOLTAGE”, depending on the

BMS digital input (DI) conguration.

Control via dry contacts (factory default)

= “NO VOLTAGE”

Control via 12 – 24 V DC signals

= “VOLTAGE”

12 –24 V DC

GND

5. Restore and fasten the upper mounting board in its original position.

6. On the terminal connector of Section C, located on the upper mounting board inside the

AHU Kit enclosure (see diagram below), connect the digital inputs (DI) as follows:

● Heating start to COM and DI1

● Cooling start to COM and DI2

● Fan mode (free cooling) start to COM and DI3

● All DI contacts open = Stop

1 2 ... 66 67 68 69 70 71 72 73 74

Sin comentarios

Panasonic PAW280MAH2 Instrucciones de operaciones Pagina 71