Panasonic PAW280MAH2 Instrucciones de operaciones descargar pdf (Pagina 63)

Control

Important

The set temperature value, which is adjustable by the above procedure, can be used in differ-

ent ways and with different functions depending on how the thermostat is used in the individual

application.

For further information see “7.2.3 Initial Settings”.

Changing values in the “Parameter” menu

To change the values of control parameters, perform the following steps:

1. Press and hold the button for approximately 3 seconds to enter the “Parameter” menu.

1 x for 3 sec.

The PV display shows “ALI”, while the current setting in the SV display is blinking.

Note: After 30 seconds of idleness, the display automatically returns from parametrization

view to normal view.

2. Press the button repeatedly to select the parameter to be changed.

repeatedly

The sequence of parameters and their range of valid values are shown in the table below.

3. Once the PV display shows the parameter to be changed and the blinking SV display shows

the currently set parameter value, use the , and buttons to set a new pa-

rameter value

4. Conrm the new setting by pressing the button.

1xbriey

5. If more than one parameter needs to be changed, repeat steps 2 through 4 for each required

parameter.

6. Once all parameters are set as required, conrm the complete parametrization by pressing

and holding the button for approximatedly 3 seconds.

1 x for 3 sec.

Parametrization is now complete. The PV and SV displays have returned to showing the cur-

rent temperature and the set temperature values respectively.

1 2 ... 58 59 60 61 62 63 64 65 66 67 68 ... 73 74

Sin comentarios

Panasonic PAW280MAH2 Instrucciones de operaciones Pagina 63