Panasonic CZ-ESWC2 Manual de instalación descargar pdf (Pagina 61)

CAUTION

Insulate both gas and liquid

tubes.

To insulate tubes

●

(1) Wrap the ﬂ are nuts with the supplied white insulating tape.

(2) Wrap the ﬂ are nuts with the supplied ﬂ are insulator.

(3) Fill the clearance between the union insulator and ﬂ are insulator

with black insulating tape. Fasten both ends of the ﬂ are insulator

with the supplied vinyl clamps.

3-58. Installing the Drain Piping

CAUTION

Water leaks may occur if the drain

pipes are connected inadequately.

(1) When rear-side drain piping is required bend the drain hose

attached to the indoor unit by 90° . Connect a drain pipe (ﬁ eld

supply) to the drain hose through the rear tubing outlet in the rear

panel. Use a hard PVC pipe (VP20) for the drain piping.

(2) Ensure that the drain pipe has a downward gradient of 1/100 or

more and that there are no water traps.

(3) Provide insulation for the drain pipe.

(4) After the drain piping is completed, pour water into the drain pan

to check that the water drains smoothly.

(5) Remove any dust or debris in the drain pan so that the pipe is not

clogged.

3-59. Installing the Remote Controller

A remote controller (optional wired remote controller) can be

mounted in the indoor unit (Floor Standing type).

(1) Remove the cover of the optional wired remote controller.

(Fig. 3-186)

(2) Remove the front panel. Remove the screws and ﬁ xture.

(Fig. 3-187)

(3) Place the remote controller into the space in the unit as shown in

Fig. 3-187. Assemble the lead wires of the remote controller to its

rear side center and route them to the lead wire guide.

(4) Secure the ﬁ xture using the supplied screws.

Fig. 3-186

To remove the cover from the remote controller, insert a screwdriver

between the cover and the controller as shown in the ﬁ gure above,

and pry off the cover.

Insulating tape (black)

Insulating tape (white)

Flare insulator

Insulator

Flare nut

Vinyl clamps

Insulating tape

Fig. 3-183

Drain hose

Drain pipe (PVC)

Fig. 3-184

Drain hose (supplied)

Drain insulator (supplied)

Vinyl clamp

(supplied)

Hose band

(supplied)

Hard PVC pipe VP20

(field supply)

Insulating tape

(supplied)

Vinyl clamps

(supplied)

Drain hose insulator

(field supply)

Fig. 3-185

Controller

Remote

Lead wire guide

Screw

Fixture

Fig. 3-187

VRF_Indoor_US.indb 61VRF_Indoor_US.indb 61 2011/09/30 12:23:112011/09/30 12:23:11

1 2 ... 56 57 58 59 60 61 62 63 64 65 66 ... 83 84

Comentarios a estos manuales

Sin comentarios

Panasonic CZ-ESWC2 Manual de instalación Pagina 61

Comentarios a estos manuales

Relacionado con productos y manuales para Acondicionadores de aire del sistema de división Panasonic CZ-ESWC2