Panasonic CZ-ESWC2 Manual de instalación descargar pdf (Pagina 60)

3-56. Removing and Attaching the Front Panel

(Floor Standing Type)

NOTE

A dew-prevention heater is secured behind the front

panel.

When removing or attaching the panel, take care not to

damage the lead wire to the heater.

How to remove the front panel

(1) Remove the 2 screws at the lower part of the front

panel.

(2) Holding A at the upper right of the unit, push up at B

at the lower right of the panel. The right side of the

front panel is removed. Then remove the left side of

the front panel following the same procedure.

(3) Cut off the binding strap to loosen the glass ﬁ ber tube.

(4) Disengage the lead-wire connector from the

dewprevention heater by pressing the tab.

(5) Remove the string connecting the front panel of the

unit by unhooking it from the ﬁ xture attached to the

panel.

How to attach the front panel

(1) Hook the string to the ﬁ xture of the front panel.

(2) Expose the tip of the dew-prevention heater from the

glass ﬁ ber tube in order to make connection smoothly.

(3) Connect the lead-wire connector to the dew-

prevention heater until the click sounds.

(4) After the connection, tighten the glass ﬁ ber tube

nearby connected area inside the tube with the

binding strap.

(5) Align the slots at the lower part of the front panel to

the tabs at the lower part of the indoor unit and put the

upper trim tab of the front panel on the groove of the

unit. Then press down the panel.

(6) Insert the 2 screws at the lower part of the front panel.

3-57. Installing the Refrigerant Tubing

(1) When connecting the gas tube use the supplied

tubing.

(2) Tubes can be extended in 2 directions: downward and

at rear.

For Floor Standing type

• When a rear tube is required, it can run through the

rear-tube outlet of the rear panel.

• When a downward tube is required, refer to the opening

dimensions shown in Fig. 3-182.

Front panel

Tab

Side panel

Fig. 3-180

Dew-prevention

heater

Fixture

Front

panel

String

Cut off the both binding straps.

Removing the front panel

Expose the tip

of the dew-

prevention

heater from the

glass fiber tube.

Disengage the

lead-wire

connector from

the dew-

prevention heater.

Tighten the

glass fiber tube

with the binding

strap at both

side.

Attaching the front panel

Expose the tip

of the dew-

prevention

heater from the

glass fiber tube.

Connect each other.

Lead-wire connector

(4P WHT)

Fig. 3-181

6-37/64"

6-31/32"

Holes for fixing the

unit to the floor

Rear-tube outlet

Refrigerant tubing

space for

downward tubing

Fig. 3-182

VRF_Indoor_US.indb 60VRF_Indoor_US.indb 60 2011/09/30 12:23:112011/09/30 12:23:11

1 2 ... 55 56 57 58 59 60 61 62 63 64 65 ... 83 84

Comentarios a estos manuales

Sin comentarios

Panasonic CZ-ESWC2 Manual de instalación Pagina 60

Comentarios a estos manuales

Relacionado con productos y manuales para Acondicionadores de aire del sistema de división Panasonic CZ-ESWC2