Panasonic dBs Instrucciones de operaciones descargar pdf (Pagina 101)

Panasonic Digital Business System - Operating Instructions

March 1997 Issue 24

101

Speed Dial Memories

System speed dials can be used over DASS II channels in the usual manner. The send character can be stored at

the end of the speed dial or manually dialled after the memory has been dialled.

If a ‘#’ is stored in the middle of a speed dial memory all digits before the ‘#’ are sent as a call request and

subsequent digits sent as tone dialling (DTMF) after answer from the called party.

Storing The Send Command Under An FF Key

An unassigned FF Key can be programmed to be a send key and used instead of the send character. The FF key

is programmed in the usual way storing the code ‘#9’

Operation:

1 Press On / Off

2 Press RECALL

3 Press The Unassigned FF Key

4 Enter the code ‘#9’

5 Press HOLD to store the code

6 Press On / Off to finish

Direct Dial In

The DBS will support Direct Dial In (DDI) from the DASS II network. The network sends the last few digits of the

incoming call’s number to the DBS which then uses this to route the call directly to a specified extension.

All settings and configuration are engineer programmable and cannot be changed by the user. Once set up

operation of the DDI function is automatically controlled by the system and its program settings.

1 2 ... 96 97 98 99 100 101 102 103 104 105 106 ... 147 148

Sin comentarios

Panasonic dBs Instrucciones de operaciones Pagina 101