Panasonic WJMP204 Instrucciones de operaciones descargar pdf (Pagina 9)

Before connecting the Data Multiplex Unit, check how the

DIP switches are set on the rear panel in cases where the

system setup must be changed.

■ Setting Communication Mode

● Panasonic Security Data Mode

Check that Dip Switches SW3 and SW4 are up.

● Camera Communication Mode

Check that Dip Switch SW3 is down and Dip Switch

SW4 up.

■ Setting VS or VD Signal Output

● Supplying Video Drive Signal in Internal Sync

Mode*

Check that Dip Switch SW1 is down (VD).

DIP SWITCH SETTING

SW3

123456

SW4

SW1

THROUGH

SW5

OFF

SW6

2-LINE

4-LINE

SW3 SW4

123456

SW1

THROUGH

* Synchronized vertical drive signal is supplied in case

of signal input to VS/VD IN connector.

● Supplying Synchronized Signal Input to VS/VD

IN Connector

Check that Dip Switch SW1 is up (THROUGH).

■ Setting the Communication

Mode via RS485 or Data Port

● Termination

Check that Dip Switch SW5 is down (ON).

Note: In case of using two Data Multiplex Units or

more, set Dip Switch SW5 on only one point at the

end position of the unit to the down position.

● Data Line Selection Mode

Set DIP Switch SW6 to the 4-LINE or 2-LINE position

according to the desired data line selection mode.

4-LINE: Full Duplex

2-LINE: Half Duplex

The initial factory setting is 4-LINE.

Note: Set SW6 to 4-LINE for communication in

Panasonic Security Data mode.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 30 31

Comentarios a estos manuales

Sin comentarios

Panasonic WJMP204 Instrucciones de operaciones Pagina 9

Comentarios a estos manuales

Relacionado con productos y manuales para Cámaras De Seguridad Panasonic WJMP204