Panasonic WJMP204 Instrucciones de operaciones descargar pdf (Pagina 7)

■ Rear View

o Camera Input Connectors 1-4 (CAMERA IN 1, 2, 3, 4)

These connectors accept the composite video signal

from the camera.

!0 Camera Output Connectors 1-4 (CAMERA OUT 1, 2,

3, 4)

The video signal connected to the Camera Input

Connector (CAMERA IN 1, 2, 3, 4) is looped through to

these connectors.

!1 Video Input Connector (SPOT IN)

Used when multiple Data Multiplex Units are connect-

ed.

Note: To connect multiplex Data Multiplex Units, set

DAISY MODE in the System menu to ON.

!2 Video Output Connector (SPOT OUT)

This connector supplies the video output signal for the

spot monitor. It is also used when connecting multiple

Data Multiplex Units.

!3 VS/VD Input Connector (VS/VD IN)

Accepts the video sync signal (VS), or a vertical drive

signal (VD) supplied by external devices to synchro-

nize the Data Multiplex Unit with other devices.

Notes:

• Connect a device supplying an external sync sig-

nal that complies with the CCIR specifications. Do

not input signals having a high jitter content such

as VTR playback signals.

• To input a vertical drive signal, set VS/VD INPUT in

the System menu to VD.

!4 VS/VD Output Connector (VS/VD OUT)

This connector is used to supply the sync signal input

to the VS/VD IN connector, or the internally generated

sync signal VD, to other devices.

Note:

• Set MODE Switch (1) to OFF (THROUGH) in sup-

plying the signals input to the VS/VD IN connector

to other devices.

• Set MODE Switch (1) to ON (VD) in supplying the

internally generated reference sync signal VD to

other devices.

!5 Alarm/Remote Connector (ALARM/REMOTE)

The factory default setting is ALARM input. For remote

input, set TERMINAL in the System menu to REMOTE.

Can also be used as ALARM/REMOTE output terminal

by moving an internal connector. Refer to page 24 for

details.

!6 RS485 Terminal (RS485)

This terminal is used to exchange control data with the

camera site via Camera Communication mode.

!7 Data Port (DATA)

This port is used to exchange control data with the WV-

CU360 System Controller in Panasonic Security Data

mode.

Note: Cannot use both RS485 Terminal and Data port

at the same time. It can be distributed correspond-

ing to the communication mode as follows:

Camera Communication Mode: Use only the RS485

terminal.

Panasonic Security Data mode: Use only the Data

port.

!8 Dip Switches (MODE)

These switches are used to select the mode.

!9 Signal Ground Terminal (SIGNAL GND)

@0 Power Cord

IN IN

CAMERA RS485

ABABG

VS/VDSPOT DATA

ALARM / REMOTE

MODE

SIGNAL GND

4321

OUT OUT

OUT

4321

!2 !4

!7 !8

!1 !3 !5 !9 @0

1 2 3 4 5 6 7 8 9 10 11 12 ... 30 31

Comentarios a estos manuales

Sin comentarios

Panasonic WJMP204 Instrucciones de operaciones Pagina 7

Comentarios a estos manuales

Relacionado con productos y manuales para Cámaras De Seguridad Panasonic WJMP204