Panasonic WV-SF548E Guía de instalación descargar pdf (Pagina 26)

When using 12 V DC power supply*

q Loosen the screws of the power cord plug

(accessory).

w Connect the cable of the 12 V DC power sup-

ply* to the power cord plug.

Strip 3 mm - 7 mm {1/8 inches - 9/32 inches}

from the end of the wire, and twist the stripped

part of the wire sufficiently to avoid short circuit.

Specification of cable (wire):

16 AWG - 24 AWG, Single core, twisted

 • Check whether the stripped part of the wireis

not exposed and is securely connected.

e Tighten the screws of the power cord plug.

(Recommended tightening torque: 0.339 N·m

{0.25 lbf·ft})

r Connect the power cord plug to the 12 V DC

power supply terminal.

* FOR UL LISTED MODEL(S), ONLY CONNECT

12 V DC CLASS 2 POWER SUPPLY.

IMPORTANT:

 • Besuretousethepowercordplugprovidedwiththisproduct.

 • Besuretofullyinsertthepowercordplug(accessory)intothe12VDCpowersupplyterminal.

Otherwise, it may damage the camera or cause malfunction.

 • Wheninstallingthecamera,makesurethatexcessiveforceisnotappliedtothepowercable.

 • BesuretouseanACadaptorcompliantwiththeSpecificationsregardingpowersourceand

power consumption. (☞ Page 43)

t Run the 12 V DC output cable through the gap of the cable hook.

12V=IN

12 V DC output cable

Cable hook

(12 V DC)

(GND)

Power cord plug

(accessory)

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 47 48

Sin comentarios

Panasonic WV-SF548E Guía de instalación Pagina 26