Panasonic WV-SF548E Guía de instalación descargar pdf (Pagina 25)

e After the cable connection, connect the exter-

nal I/O terminal plug to the external I/O termi-

nals of the camera.

IMPORTANT:

 • Donotconnect2wiresormoredirectlytoaterminal.Whenitisnecessarytoconnect2wires

or more, use a splitter.

 • InputandoutputoftheEXTI/Oterminal2and3canbeswitchedbyconfiguringthesetting.

"Off" is selected by default. It is possible to determine whether or not to receive input from EXT

I/O terminal 2 and 3 (ALARM IN2, 3) by selecting "Off", "Alarm input", "Alarm output" or "AUX

output"for"Terminal2" or "Terminal3"onthe[Alarm]tabonthe"Alarm"page.Refertothe

Operating Instructions (included in the CD-ROM) for further information.

 • Connectanexternaldevicewithverifyingthattheratingsarewithinthespecificationsbelow.

 • WhenusingtheEXTI/Oterminalsastheoutputterminals,ensuretheydonotcausesignalcol-

lision with external signals.

 • ALARMOUT,AUXOUT

Output specification: Open collector output (maximum applied voltage: 20 V DC)

Open: 4 V - 5 V DC by internal pull-up

Close: Output voltage 1 V DC or less (50 mA or less)

 • ALARMIN

Input specification: No-voltage make contact input (4 V - 5 V DC, internally pulled up)

OFF: Open or 4 V - 5 V DC

ON: Make contact with GND (required drive

current: 1 mA or more)

b Connect a LAN cable (category 5 or better,

STP*) to the network connector.

* E models only

n Connect the power supply.

IMPORTANT:

 • The 12 V DC power supply shall be insulated

from the commercial AC power.

Network connector

External I/O terminals

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 47 48

Sin comentarios

Panasonic WV-SF548E Guía de instalación Pagina 25