Panasonic WV-CW504 Guía de instalación descargar pdf (Pagina 27)

Waterproof treatment for the cable joint sections

Adequate waterproof treatment is required for the cables when the camera with exposed cables is

installed by means of the camera mount bracket or it is installed under the eaves. The camera body

is waterproof, but the cable ends are not waterproof.

Be sure to use the supplied butyl tape at the connection parts of the power cord and video output

cable to apply waterproof treatment in the following procedure. Failure to observe this may cause

water leakage resulting in malfunction.

Stretch the tape by approx. twice (see the illustration below) and wind it around the cable. Insuffi-

cient tape stretch causes insufficient waterproofing.

Note:

 • Toinstallthisproductoutdoors,besuretowaterproofthecables.Thecamerabodyiswater-

proof (IEC IP66 or equivalent) only when installation specified in this document and appropriate

waterproofing are properly performed. The bracket is not waterproof.

 • Thecableshallbewoundwithbutyltapeinahalf-overlappingmanner.

When using power

cord

When using video output cable

Dobled length

Stretch the tape to about twice.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 43 44

Sin comentarios

Panasonic WV-CW504 Guía de instalación Pagina 27