Panasonic WV-CW504 Guía de instalación descargar pdf (Pagina 23)

Adjust the camera

Be sure to view the monitor for adjustment when the camera angle is adjusted.

Connect the monitor for adjustment (e.g. a small LCD) to the monitor output connector, and

adjust the camera angle.

When determining the camera angle, repeat fine follow the adjusting procedure of q, w, and

e shown below.

q Loosen the panning lock screw and rotate the camera head horizontally to adjust panning,

and tighten the panning lock screw.

w Loosen the tilting lock screws and rotate the camera head vertically to adjust tilting, and

tighten the tilting lock screw.

e Rotate the tilt adjusting table, and adjust the azimuth angle of the image.

Important:

 • Thepanninglockscrewandthetiltinglockscrewshallbesecurelytightened.

(Recommended tightening torque: 0.59 N·m)

Note:

 • ThevideooutputtotheBNCconnectorwillbeinterruptedwhileanadjustingmonitoriscon-

nected to the monitor output connector.

 • Atthesametimeforthepanandtiltadjustments,makefocusadjustmentsofStep2.

75 °

Tilting lock screw

Monitor output connector

(RCA)

Tilt adjusting table

Panning lock screw

Panning table

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 43 44

Sin comentarios

Panasonic WV-CW504 Guía de instalación Pagina 23