Panasonic WV-CW504 Guía de instalación descargar pdf (Pagina 26)

b Mount the enclosure and inner

dome.

Tighten the screws that have been loos-

ened in Step 2 in page 22 using the sup-

plied driver bit.

(Recommended tightening torque:

0.78 N·m)

Important:

 • Attachtheinnerdome in accordancewith

the lens direction to not to change the lens

direction.

 • Check if the tabs of the inner dome are

firmly fit.

 • Remove the cushioning (pink sheet) from

the inside of the dome and the protection

sheet from the outside of the dome.

Note:

 • Defocusmaybecausedbythereinstalledenclosure.Whenusingasystemcontroller(option),

adjust the back-focus on the setup menu after attaching the enclosure. (+ Operating Instruc-

tions (PDF))

 • Whennotusingasystemcontroller,byusingthe[ABF2]buttonback-focusadjustmentisavail-

able after attaching the enclosure. The procedure for the use of the [ABF2] button is as speci-

fied below.

q Press the [ABF2] button. → The ABF operation indicator will start blinking.

w While the indicator is blinking (for around 3 minutes), attach the enclosure to the camera.

e When the indicator changes to steady light, back-focus will be adjusted automatically. After

the back-focus is adjusted, the indicator will go out.

* Do not aim the camera to objects continuously moving.

* If the indicator blinks again after changing to steady light, back-focus adjustment may have

failed. In this case, check the back-focus on the LCD monitor.

To adjust the back-focus again, perform Step q to e again.

Cutout for

mounting

Groove for

mounting

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 43 44

Sin comentarios

Panasonic WV-CW504 Guía de instalación Pagina 26