Panasonic CS-MKS12NKU Manual de operaciones

Operating InstructionsCS-MKS7NKUCS-MKS9NKUCS-MKS12NKUAPPENDIX A(852-6-4181-214-00-2)A-1

9REMOTE CONTROLLER (CONTINUED)Temperature setting buttons(TEMP.)Press the button to increase the set temperature.Press the button to reduce the se

10REMOTE CONTROLLER (CONTINUED)USING THE REMOTE CONTROLLERTemperature Display SelectorbuttonThis switches the temperature display between °C and °F.Ti

11USING THE REMOTE CONTROLLER (CONTINUED)How to Use the RemoteControllerWhen using the remote controller, always point the unit’s transmitter head dir

12OPERATION WITH THE REMOTE CONTROLLER1. OperationCheck that the circuit breaker on the power panel is turned on.Press the setting buttons as describ

13OPERATION WITH THE REMOTE CONTROLLER (CONTINUED)• Choose the best position in the room for the remote controller, which also acts as the sensor for

14OPERATION WITH THE REMOTE CONTROLLER (CONTINUED)4. Night Setback ModeNight Setback Mode is used for saving energy.Press the NIGHT SETBACK button wh

15OPERATION WITH THE REMOTE CONTROLLER (CONTINUED) 5. QUIET ModeQUIET Mode is used to reduce the fan sound of the indoor unit. Press the QUIE

16SPECIAL REMARKSHow it works? • Once the room temperature reaches the level that was set, the unit’s operation frequency is changed automatically.• D

17SETTING THE TIMERIn the descriptions below, the following settings are used for the temperature and time indicator selector button on the bottom fro

18SETTING THE TIMER (CONTINUED)3. How to set the ON time(Example) To start operation at 7:10 am.4. How to set DAILY ON/OFF REPEAT timer(Example) To st

This air conditioner uses the refrigerant R410A.Split System Air ConditionerModel No.Panasonic Corporation1006 Kadoma, Kadoma City, Osaka, Japan852641

19USING THE 1-HOUR OFF TIMERTIPS FOR ENERGY SAVING1. 1-Hour OFF Timer This function causes the unit to operate for one hour and then stop, regardless

20ADJUSTING THE AIRFLOW DIRECTION1. Horizontal The horizontal airflow can be adjusted by moving the vertical vanes with your hands to the left or righ

21OPERATION WITHOUT THE REMOTE CONTROLLERCARE AND CLEANINGINDOOR UNIT If you have lost the remote controller or it has trouble, follow the steps below

22CARE AND CLEANING (CONTINUED)Filter The filter behind the air intake grille should be checked and cleaned at least once every two weeks.How to remov

23CARE AND CLEANING (CONTINUED)WIRED REMOTE CONTROLLERCleaning the main unit andRemote Controller• Wipe clean using a soft, dry cloth.• To remove stub

24TROUBLESHOOTING (BEFORE CALLING FOR SERVICE)If your air conditioner does not work properly, first check the following points before requesting servi

25SPECIFICATIONSModel No.Indoor UnitCS-MKS9NKUCS-MKS7NKUSingle-phase, 208-230 V, 60 HzHeating CapacityOperationSoundUnit Dimensions (H×W×D)(Indoor uni

Operating InstructionsCS-MKS18NKUCS-MKS24NKU(852-6-4181-215-00-1)APPENDIX BA-2

This air conditioner uses the refrigerant R410A.Split System Air ConditionerModel No.Panasonic Corporation1006 Kadoma, Kadoma City, Osaka, Japan852641

2FEATURESThis air conditioner is an inverter type unit that automatically adjusts capability as appropriate. Details on these functionsare provided be

2FEATURESThis air conditioner is an inverter type unit that automatically adjusts capability as appropriate. Details on these functionsare provided be

3INSTALLATION LOCATION• We recommend that this air conditioner be installed properly by qualified installation technicians in accordance with the Inst

4• To prevent possible hazards from insulation failure, the unit must be grounded.• Do not clean inside the indoor and outdoor units by users. Engage

5NAMES OF PARTSThis illustration is based on the external view of a standard model.Consequently, the shape may differ from that of the air conditioner

6UNIT DISPLAY AND OPERATION BUTTONREMOTE CONTROL receiver This section picks up infrared signals from the remote controller (transmitter).OPERATION bu

7REMOTE CONTROLLER (DISPLAY)(1) Operation modeMILD DRY ...COOL ...FAN ...

8REMOTE CONTROLLERThe illustration above pictures the remote controller after the cover has been opened.Transmitter When you press the buttons on the

9REMOTE CONTROLLER (CONTINUED)Temperature setting buttons(TEMP.)Press the button to increase the set temperature.Press the button to reduce the se

10REMOTE CONTROLLER (CONTINUED)USING THE REMOTE CONTROLLERTemperature Display SelectorbuttonThis switches the temperature display between °C and °F.Ti

11USING THE REMOTE CONTROLLER (CONTINUED)How to Use the RemoteControllerWhen using the remote controller, always point the unit’s transmitter head dir

12OPERATION WITH THE REMOTE CONTROLLER1. OperationCheck that the circuit breaker on the power panel is turned on.Press the setting buttons as describ

3INSTALLATION LOCATION• We recommend that this air conditioner be installed properly by qualified installation technicians in accordance with the Inst

13OPERATION WITH THE REMOTE CONTROLLER (CONTINUED)• Choose the best position in the room for the remote controller, which also acts as the sensor for

14OPERATION WITH THE REMOTE CONTROLLER (CONTINUED)4. Night Setback ModeNight Setback Mode is used for saving energy.Press the NIGHT SETBACK button wh

15OPERATION WITH THE REMOTE CONTROLLER (CONTINUED) 5. QUIET ModeQUIET Mode is used to reduce the fan sound of the indoor unit. Press the QUIE

16SPECIAL REMARKSHow it works? • Once the room temperature reaches the level that was set, the unit’s operation frequency is changed automatically.• D

17SETTING THE TIMERIn the descriptions below, the following settings are used for the temperature and time indicator selector button on the bottom fro

18SETTING THE TIMER (CONTINUED)3. How to set the ON time(Example) To start operation at 7:10 am.4. How to set DAILY ON/OFF REPEAT timer(Example) To st

19USING THE 1-HOUR OFF TIMERTIPS FOR ENERGY SAVING1. 1-Hour OFF Timer This function causes the unit to operate for one hour and then stop, regardless

20ADJUSTING THE AIRFLOW DIRECTION1. Horizontal The horizontal airflow can be adjusted by moving the vertical vanes with your hands to the left or righ

21OPERATION WITHOUT THE REMOTE CONTROLLERCARE AND CLEANINGINDOOR UNIT If you have lost the remote controller or it has trouble, follow the steps below

22CARE AND CLEANING (CONTINUED)Filter The filter behind the air intake grille should be checked and cleaned at least once every two weeks.How to remov

4• To prevent possible hazards from insulation failure, the unit must be grounded.• Do not clean inside the indoor and outdoor units by users. Engage

23CARE AND CLEANING (CONTINUED)WIRED REMOTE CONTROLLERCleaning the main unit andRemote Controller• Wipe clean using a soft, dry cloth.• To remove stub

24TROUBLESHOOTING (BEFORE CALLING FOR SERVICE)If your air conditioner does not work properly, first check the following points before requesting servi

25SPECIFICATIONSModel No.Indoor UnitSingle-phase, 208-230 V, 60 HzHeating CapacityOperationSoundUnit Dimensions (H×W×D)(Indoor unit : Include panel)Ne

5NAMES OF PARTSThis illustration is based on the external view of a standard model.Consequently, the shape may differ from that of the air conditioner

6UNIT DISPLAY AND OPERATION BUTTONREMOTE CONTROL receiver This section picks up infrared signals from the remote controller (transmitter).OPERATION bu

7REMOTE CONTROLLER (DISPLAY)(1) Operation modeMILD DRY ...COOL ...FAN ...

8REMOTE CONTROLLERThe illustration above pictures the remote controller after the cover has been opened.Transmitter When you press the buttons on the