Panasonic WV-ASR500 Guía de instalación descargar pdf (Pagina 31)

PTZ configuration

This section discusses the "PTZ" section of the "Camera Settings" page, which allows you to identify a camera

as a PTZ device and configure PTZ presets.

Select the camera's COM port from the "Serial q

Port" drop-down list. This port is configured on

the "Serial Ports" page.

Select the camera's Address as w configured on the

camera hardware. (The protocol is automatically

displayed based on the Serial Port selected.)

The [Settings] button under "PTZ e " opens the "PTZ

Settings" window, which is described on the fol-

lowing page.

To enable digital PTZ/Fisheye functions, select the r

"Enable" checkbox. This is available even if the

camera is not mechanically capable of PTZ/

Fisheye functions.

The [Settings] button under t "Digital PTZ/Fisheye"

opens the "Digital PTZ Settings" window, which is

described after the Analog PTZ Control descrip-

tion.

Note:

When you create a PTZ preset, it is initially named •

"New preset_1" by default. Then, if a PTZ preset

named "New preset_1" exists, the next PTZ pre-

set is named "New preset_2". However, if you

create a new digital preset, it will also be named

"New preset_1", regardless of whether there is

already a PTZ preset with that name. To avoid

having both a PTZ preset and a digital preset with

the same name, make sure you enter a unique

name for each preset that you create.

q w e t

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 68 69

Sin comentarios

Panasonic WV-ASR500 Guía de instalación Pagina 31