Panasonic Removable Full Front CD Player/Receiver with Dot M Manual de usuario descargar pdf (Pagina 52)

Installation Guide

(continued)

Speakers

Connect the speaker wires. See the wiring diagram

{page 56) for the proper hookups. Follow the dia

gram carefully to avoid damaging the speakers and

the stereo unit.

The speakers used must be able to handle more

than 50 W of audio power. If using an optional

audio amplifier, the speakers should be able to han

dle the maximum amplifier output power. Speakers

with low input ratings can be damaged. Speaker im

pedance should measure 4-8 Q, which is typically

marked on most speakers. Lower or higher imped

ance speakers will affect output and can cause both

speaker and stereo unit damage.

Motor Antenna

Connect the car motor antenna lead to the dark blue

motor antenna relay control lead.

{Do not confuse the antenna lead with blue/white

stripe lead for a power amplifier.)

Battery

Connect the yellow battery lead to the correct radio

wire or to the battery fuse port on the fuse block.

Antenna

Connect the antenna by plugging the antenna lead

into the antenna receptacle.

Equipment

Connect any optional equipment such as an amplifi

er, according to the instructions furnished with the

equipment. Leave about 12" (30 cm) of distance be

tween the speaker leads/amplifier unit and the an-

tenna/antenna extension cord. Read the operating

and installation instructions of any equipment you

will connect to this unit.

Power

Connect the red power lead to the correct car radio

wire or to the appropriate fuse port on the fuse

block.

If the stereo unit functions properly with all these

connections made, disconnect the wires and pro

ceed to the final installation.

□ Final Installation

Lead Connections

Connect all wires, making sure that each connection

is insulated and secure. Bundle all loose wires and

fasten them with tape so they will not fall down

later. Now insert the stereo unit into the mounting

collar.

Congratulations! After making a few final checks,

you’re ready to enjoy your new auto stereo system.

□ Final Checks

1. Make sure that all wires are properly connected

and insulated.

2. Make sure that the stereo unit is securely held in

the mounting collar.

3. Turn on the ignition to check the unit for proper

operation.

If you have difficulties, consult your nearest author

ized professional installer for assistance.

□ Preparation

We strongly recommend that you wear gloves

for installation work to protect yourself from

injuries.

When bending the mounting tabs of the

mounting collar with a screwdriver, be careful

not to injure your hands and fingers.

terminal {see caution below).

' Unit should be installed in a horizontal position

with the front end up at a convenient angle, but

not more than 30°.

Less than 30®

Caution:

• Do not disconnect the battery terminals of a

car with a trip or navigational computer since

all user settings stored in memory will be lost.

Instead take extra care with installing the unit

to prevent shorts.

Dashboard Installation

Installation Opening

23/32"

1(53 mm)

- 75/32" -

(182 mm)

This unit can be installed in any dashboard having

an opening as shown above. The dashboard should

3/ie"

(4.75 mm) —

Узг"

(5.56 mm) thick in order to

be able to support the unit.

GQ;DRX9837DF.9D3U

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 155 156

Comentarios a estos manuales

Sin comentarios

Panasonic Removable Full Front CD Player/Receiver with Dot M Manual de usuario Pagina 52

Comentarios a estos manuales

Relacionado con productos y manuales para Altavoces del coche Panasonic Removable Full Front CD Player/Receiver with Dot M