
17
VQT0X49
∫ About the SD cards that you can use
¢ The recording may suddenly stop during motion picture recording. (P38)
∫ About the SD card
≥ Do not touch the terminals on the back of the SD card.
≥ Electrical noise, static electricity or the failure of this unit or the SD card may damage
or erase the data stored on the SD card. Save important data recorded on this unit to
a PC using the USB cable (supplied), MotionSD STUDIO etc. (P77) (We recommend
using MotionSD STUDIO to acquire data recorded on this unit.)
≥ When using an SD card on which data has been written many times, the remaining
time left for recording may be reduced. (P38)
∫ About the card access lamp
≥ When this unit accesses the SD card (reading, recording, playback, erasing, etc.),
the access lamp lights up.
≥ If the following operations are performed when the access lamp is lit, then the SD
card or the recorded data may be damaged or this unit may malfunction.
– Opening the card slot cover and inserting or removing the SD card.
– Operating the [ON/OFF] switch or the mode dial.
– Removing the battery or AC adaptor.
∫ About the write protection switch on the SD card
≥ The SD card has a write protection switch 1 on it. If the switch is
moved to [LOCK], you cannot write to the SD card, delete the
data on it or format it. If it is moved back, you can.
Recording mode
SD Memory card capacity
SDHC Memory
card capacity
8MB, 16MB
32 MB, 64 MB,
128 MB
256 MB,
512MB, 1GB,
2GB
4GB
(Maximum)
Motion picture
recording mode
Cannot be
used.
Cannot be
guaranteed in
operation.
¢
Refer to page 37.
Still picture
recording mode
Can be used.
This unit is compatible with both SD Memory cards and SDHC Memory cards. You
can only use SDHC Memory cards on devices that are compatible with them. You
cannot use SDHC Memory cards on devices that are only compatible with SD
Memory cards. (When using a SDHC Memory card on another device, be sure to
read the operating instructions for that device.)
2
1
VQT0X49ENG.book 17 ページ 2006年6月6日 火曜日 午後2時1分
Comentarios a estos manuales