Panasonic Arbitrator 360 Instrucciones de operaciones Pagina 87

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 119
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 86


Setup
(continued)
Camera 1
Camera 1 settings can be performed.
Item Factory-Preset Description
Camera 1 Settings for the color camera connected to the [CAMERA 1] connector
on the Memory Card Video Recorder
IR Level LOW Level setting for automatic IR switching*
1
Setting values: LOW, HIGH
IR Time [s] 30 Level detection time for automatic IR switching*
1
(seconds)
Setting values: 10, 30, 60, 300
Auto Zoom
Magnication
10 Maximum magnication setting for automatic zooming
Setting values: 1, 2, 3, 4, 5, 7, 10, 15, 22
Auto Zoom Time [s] 3 Keeping time of the maximum zoom magnication during automatic
zooming (seconds)
Setting values: 3, 5, 8
Auto Zoom End
Position
1 Automatic zooming end position setting
Setting values: 1, 2, 3, 4, 5, 7, 10, 15, 22, LAST
Zoom Limit 220 Maximum magnication during zoom
Setting values: 22, 220
AGC Level HIGH Automatic gain control setting for the color camera
Setting values: LOW, MID, HIGH, OFF
Flip OFF Vertical ipping of the output image from the color camera
Setting values: ON (vertically ipped)
OFF (No ipping)
Auto Focus PRESET The focusing method of the color camera in the following conditions can
be set:
When "Init LPR Mode" is set to "DISABLE"
When "Init LPR Mode" is set to "ENABLE" and "LPR Mode" is set to
"PATROL"
When recording is started by a recording trigger signal with "Init LPR
Mode" set to "ENABLE" and "LPR Mode" set to "LPR"
Setting values:
PRESET (When the zoom magnication is set to ×3 or less, the
camera focuses on an object at about 15 m distance from the
camera. If zooming operation is performed afterward, automatic
focusing will be activated.)
DISABLE (The focal position is xed at a distance of about 40 m,
and automatic focus is disabled.
AUTO (Auto focusing when zooming magnication changes)
*1 The [IR Level] and [IR Time] settings are enabled
only when [Init IR Mode] is set to "AUTO."
(to be continued to the next page)
Vista de pagina 86
1 2 ... 82 83 84 85 86 87 88 89 90 91 92 ... 118 119

Comentarios a estos manuales

Sin comentarios