Panasonic WJ-HD616 Guía de instalación descargar pdf (Pagina 94)

ConfigurethesettingsrelatingtoRS485[RS485setup]

Select the [RS485 setup] tab on the "Communication" page. (+ Page 60)

The settings for RS485 can be configured on this tab.

[Protocol]

Select the protocol used for RS485 communication.

Panasonic/Pelco-D

Default: Panasonic

[Baudrate]

Select a communication speed for data transmission with a

connected device from the following:

2 400/4 800/9 600/19 200/38 400 (bps)

Default: 19 200

[Controlcamerach]

Allocate the RS485 port 1 and port 2 to camera channels.

When the [Setup] button is selected, the following page will

be displayed.

 • [TERM]

Select a port to be controlled from the following for each

camera channel.

PORT1: Controls from the RS485 port 1.

PORT2: Controls from the RS485 port 2.

 • [Back]button

Closes the setup page and returns to the [RS485 setup]

tab.

[Databit]

The data length for communication will be displayed.

7/8 (bit)

Default: 8

[Parity]

Methods of error check for a transmission at communication

will be displayed.

NONE: No parity check

EVEN: Even parity

ODD: Odd parity

Default: NONE

[Stopbit]

Stop bit types will be displayed.

1/2 (bit)

Default: 1

1 2 ... 89 90 91 92 93 94 95 96 97 98 99 ... 155 156

Sin comentarios

Panasonic WJ-HD616 Guía de instalación Pagina 94