Panasonic DATA LINK KX-TCL100-B Manual de usuario

jjrOUCH TONE ONLYPLEASE READ BEFORE USE AND SAVE.Charge the battery for about 15 hours before initial use

ietiSogsInstalling the Battery in the Remote Unit1Install the battery as shown observing the proper polarity. The connector is keyed and can only be i

rConnectionOUSE ONLY Panasonic AC ADAPTOR KX-TCA7. ©The AC adaptor must remain connected at all times. {It may feel warm during use. This is normal.)1

C> SettingsIf you purchased an optional AC adaptor for the remote unit, the remote unit must first be placed on the base unit for a few seconds to

Battery informationIf your Panasonic battery is fully charged;OperationApprox. Battery LifeWhile in use (Operation) Up to about 2.0 hoursWhile not in

[> SettingsMounting the Remote UnitThe remote unit can be mounted on a personal computer.Find a convenient place on the back of your laptop screen

oThe double-sided tape uses a strong adhesive. Be careful when removing the computer mounting bracket from a personal computer or you may damage the c

Operaifomi1Adjust the remote unit’s antenna so that it is vertical and slide the POWER switch on the remote unit to the ON position.oThe IN USE/RANGE

4After use, slide the POWER switch OFF.oAt the end of your session, the modem will hang-up the phone line and the unit will enter the standby mode.If

OpiSoimal AC AdaptorAn optional AC adaptor is available for the remote unit to extend the usage time of the unit.Please Purchase a Panasonic KX-TCA7 A

Bateiry RepHacemeDiltIf the ВАТТ LOW/CHARGE indicator flashes after being fully charged, replace the battery with a new Panasonic KX-TCA8 battery.{To

Before loDfiall UsePlease read IMPORTANT SAFETY INSTRUCTIONS on pages 23-25 before use. Read and understand all Instructions.Thank you for purchasing

Beffor© RecgyesiDinig IHlelpProblemRemedyThe IN USE/RANGE indicator flashes green.©This is normal when the remote unit is receiving an incoming call o

ProblemRemedyAll indicators on the remote unit flash or the communication does not link.©This indicates the security code has been lost. Place the rem

Do not connect this unit to a digital PBX (switchboard) telephone system, as the voltages on digital lines may damage the unit. This unit was designed

Imporîainit Safety llinistiryctioinisc>When using this unit, basic safety precautions should always be followed to reduce the risk of fir

[> Important Safety Instructions12. Unplug this unit from the wall outlet and refer servicing to an authorized servicenter when the following cond

CAUTION:To reduce the risk of fire or injury to persons, read and follow theseinstructions.1 Use only the battery{ies) specified.2. Do not dispose o

FCC aodl Otlhi®i" loformaliioin)If requested by the telephone company, inform them as follows:FCC Registration No...

oThis device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful inter

C> FCC and Other InformationoEnvironment—do not place the unit in room where the temperature is less than 5“C (41°F) or greater than 40°C (104&apos

For product serviceo Panasonic Servicenters are listed in the servicenter directory. oCall 1-800-545-2672 for the location of an authorized servicente

Accessories (To order accessories, call 1-800-332-5368.)

©This product is designed for use in the United States of America. Sale or use of this product in other countries may violate local laws. oCe appareil

Panasonic Consumer Electronics Company,Division of Matsushita Electric Corporation of AmericaOne Panasonic Way, Secaucus, New Jersey 07094Panasonic Sa

Battery ChargeA rechargeable Ni-Cd battery powers the remote unit. Install the battery (p. 10) and charge it for about 15 hours before initial use (P.

Comiteinilis¡MffsmfSsBdLocation of ControlsRemote Unit...Base Unit...Settings ...

Remote UnoiDo not force the antenna beyond the stopper. The antenna rotates approximately 270 degrees.IN USE/RANGE Indicator {p. 7)

i>Remote unit indicatorIN USE/RANGE indicatorGreenThe communication quality between the remote unit and the base unit is good.FlashingGreenThe remo

[> Location of ControlsBase UnitThe antenna rotates approximately 200 degrees.8

Base unit indicatorCHARGE indicatorRedThe remote unit’s battery is being charged. This is normal when the remote unit is on the base unit.OffThe base