Panasonic PTL6500UL Manual de usuario descargar pdf (Pagina 3)

Signal Level Contents Description

Sync. method Asynchronous Synchronizes every 1 character (8

bits)

Baud rate Conforms

9 600 bps Data transfer speed

Parity RS-232C None Error detection method

Character length standard 8 bits Number of bit composing 1 character

Stop bit 1 bit Uses stop bit when asynchronous

method

X parameter Not used

S parameter Not used

6.4. Basic Format

The data sent from the PC to the projector is transmitted in the format shown below.

Cautions:

- When it is unnecessary to designate an ID code, send the format without the part to

ID designate it. In this case, the projector sends a call back to the PC irrespective of

the projector ID setting.

- Add a parameter when the command function is required of it.

- If sending multiple commands, check that a call back has been received from the

projector for one command before sending the next command.

Notes:

- When a command which does not require parameters is sent, the colon (:) is not

required.

- If a command is sent with a projector ID specified, the projector will return call back

only if the ID contained in the command matches the projector ID or the projector ID

is set to ALL.

- Projector ID supported on the RS-232C interface is 00 (ALL) to 99.

- When using control from REMOTE terminal, commands cannot be received at SERIAL

terminal.

6.5. Control / Query Commands

1 2 3 4 5 6 7 8

Sin comentarios

Panasonic PTL6500UL Manual de usuario Pagina 3