Panasonic CZCWEBC2 Manual de usuario descargar pdf (Pagina 27)

8 Initial Settings

8.2 Unit/Tenant

If you log in using the administrator user account, when “3. Initial settings: 2. Unit/Tenant” is

selected from the menu, the screen shown below is displayed.

Setting of the central control addresses, unit names, and tenants can be made.

 The address for each indoor unit is displayed. The display format is “Outdoor system

address – Indoor address”.

 The current central control address for each indoor unit is displayed.

To set or change a central control address, click on the cell you wish to set/change then

enter a value in the range of 1–64.

In a case of group control, a sub unit cannot be selected. The central control address of

the main unit will be applied to the sub units.

If a value outside the range of 1–64 is entered, the message shown below is displayed.

 If you click on “Auto”, the central control addresses will be automatically allocated

from 1 to the indoor units in ascending order of the indoor unit address.

The same central control address must not be assigned to two or more indoor units

belonging to the same link system. Any such invalid input will be cancelled.

If another piece of central control equipment (system controller, etc.) is connected, it

is recommended to set the central control addresses on such equipment.

Main Sub

       

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 52 53

Sin comentarios

Panasonic CZCWEBC2 Manual de usuario Pagina 27