Panasonic EY6181 Manual de usuario descargar pdf (Pagina 6)

PART IDENTIFICATION

@ Keyless drill chuck

Note: When attaching or removing bit, be

sure to set the reversing lever to the

center (switch lock) position.

This tool is equipped with a keyless drill

chuck.

1) Attachment

Insert the bit and turn the lock collar

clockwise (looking from the front) to

tighten.

When clicking sounds stop while

tightening, attachment is completed.

2)

Removal

Turn it counterclockwise (looking from

the front), then remove the bit.

Lock collar

Note: If the bit cannot be removed by hand,

insert the lock release rod or a similar

tool into the hole located on the chuck

to release the lock, and then turn the

lock collar counterclockwise (viewed

from the front).

Lock release rod

(To prevent accidental operation, remove the

battery pack before trying to remove the bit.)

Note: If excessive play occurs in the chuck,

(T) secure the drill in place and tighten the

chuck by turning @ clockwise, open

the chuck claws by unscrewing the lock

collar and (3) tighten the screw (left handed

screw) with a screwdriver by turning it

counterclockwise (viewed from the front).

D Clutch handle

(Clutch Torque Setting)

Adjust the torque out of 21 steps according

to the work. There is about 0.2 Nm (2kg*cm,

1.7 in. lbs.) interval between each step.

CAUTION! Test the setting before actual

operation.

Set the scale at this line

Scale

Torque

Reference of work

1

Approx. 0.5 Nm,

(5 kg-cm, 4.3 in. lbs.)

For driving machine

screws

6

Approx. 1.5 Nm,

(15 kg-cm, 13.0 in. lbs.)

For driving screws

into soft materials

11

Approx, 2.5 Nm,

{25 kg-cm, 21,7 in. lbs.)

For driving terminal

screws

16

Approx. 3.4 Nm,

(35 kg-cm, 30.4 in. lbs.)

For driving screws

into hard wood

21

Approx. 4.4 Nm,

(45 kg-cm, 39.0 in. lbs.)

High speed

For powerful driving

and drilling

Low speed

1 2 3 4 5 6 7 8 9 10 11 ... 15 16

Comentarios a estos manuales

Sin comentarios