Panasonic TC-29GA30R Manual de usuario descargar pdf (Pagina 24)

1

III "■

-----------------------

--

1

DISPLAY

□

TV/AV

□

PRE.

□ □ □ □

- V A

L... j 1

6 4

©a

®(i

How to switch the power ON or OFF

The TV set must first be switched on at the

wall outlet and at the Power Switch. (Refer to

page 8).

Push this button to turn the TV set ON, from

STANDBY mode.

Push it again to turn the TV set OFF,

STANDBY mode.

Note:

It is also possible to turn the TV set on

STANDBY by pushing the “Direct Pro

gramme Number Selection" Buttons (0-9)

and the “Programme Number Up or Down"

Button, either on the set or on the Remote

Control.

Programme Number Selection

Push the Programme Number Up “a” or

Down “v” Button to select the next higher or

lower Programme number.

Direct Programme Number Selection

(CH SELECT = POS.)

You can select the numbers directly by

pushing “Number 0-9” button and the two

digit Numbers by pushing Two Digif and

“Programme Number” buttons.

Programme Numbers...

Programme Number 12.

©.®.@

Direct Programme Number Selection

<CH SELECT s DIRECT)

You can select the number directly by push

ing the corresponding programme number

button.

Programme Number 8

..........

(J)

Programme Number 36

........

(T)»®

Programme Number 124.,,. ®,®,®

Note:

When the Skip setting for Programme

Number 100 through 125 is on, the channel

selection time will be shorted, and thus you

can not input three digits at a time.

TV/AV

TV/AV Mode Selection

Push the TV/AV" Button to select TV, AV1,

AV2, AV3 input signal modes sequentially.

TV/A

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 43 44

Comentarios a estos manuales

Sin comentarios