Panasonic WV-CF304L Guía de instalación Pagina 14

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 32
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 13
14
Remove the dome cover
1 Peel off the protection sheet from the dome
cover. Don't remove completely as this
protects the dome during installation.
2 Loosen the dome cover fixing screw.
3 Adjust the mark on this unit to [|] on the
dome cover, and turn the dome cover
counterclockwise to remove it.
When installing the camera on a wall or ceiling, there are two methods as specified below.
• Usethetwo-gangjunctionbox
• Installingthecameradirectlyonawallorceiling
Important:
• Procure4screws(M4)tosecurethecameratoawallorceilingaccordingtothematerialofthe
installation area. Do not use wood screws and nails. For mounting a camera on a concrete wall
orceiling,useananchorbolt(M4)forsecuring.
(RecommendedtighteningtorqueM4:1.6N·m{1.18lbf·ft})
Requiredpull-outstrengthofasinglescrew/boltis196Normore.
• Ifaceilingboardsuchasplasterboardistooweaktosupportthetotalweight,theinstallation
areashallbesufficientlyreinforced.
• Theprotectionsheetattachedtothedomesectionshouldbepeeledoffafterinstallation.
The mounting conditions of the camera are described as follows:
Preparations
Installation
place
Applicable mount
bracket
Recommended
screw
Number
of screw
Minimum pull-out
strength (per 1 pc.)
Ceiling/wall
Two-gangjunctionbox
(locallyprocured)
M4 4pcs. 196N
Ceiling/wall (Directmounting) M4 4pcs. 196N
Fixing screw
Cover
Dome cover
Vista de pagina 13
1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 31 32

Comentarios a estos manuales

Sin comentarios