Panasonic TC-LT1 Series Manual de usuario descargar pdf (Pagina 20)

Projecting With the Setting You Desire

AV/RGB Selection

(Projector) (Remote Control)

To switch inputs press the AV/RGB switching button on the projector, or the

remote control. Inputs will be switched in the following order:

Signals from the device connected to

AV1 Input will be projected.

Signals from the device connected to Signals from the device connected

AV2 Input will be projected. to the RGB Input will be projected.

Please do not connect cables to the S-Video Input Terminal if you wish to project a video signal from the video

input terminal.

At the time of shipment, the default colour projection for Auto or RGB input is set to Auto. If the images are not

being projected correctly, however, it may be necessary to change the setting to match the input signal.

Piease see p. 23 for selection of colour standard for the video input signal. Please p. 25 for selection of mode

for the RGB input signal.

Using with the Picture Menu of Your

Remote Control Pressing the Picture Menu Button on the remote control wilt switch

Standard picture Soft Picture Bright Picture

• The selected Picture Menu will be memorized for each input switching.

• The contents of the Picture Menu (colour, contrast, etc.) let you make the desired changes. (See page 21,

I i.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 39 40

Sin comentarios

Panasonic TC-LT1 Series Manual de usuario Pagina 20