Panasonic PANASYNC/PRO TX-D1F64 Manual de usuario descargar pdf (Pagina 14)

Adjustments (Continued)

Adjustments menu

Signal ! Use the S and B keys to select either the rear panel input terminal port A

(Mini D-Sub type) or Port B (BNC) type.

This displays the input synchronization signal frequency.

Information on the input screen mode (resolution, horizontal and vertical

synchronization frequency) will be displayed on the display monitor. There are

occasions sometimes when some screen modes in use do not display any

resolution. Direct display allows this to be displayed on screen by pressing

the \J} key even when the menu screen is not displayed.

Self-Test menu (No Signal screen)

This display indicates that the monitor is operating normally. When one of the following

conditions occurs, press one of the 4 operation keys to call the appropriate display.

No Signal

fH —.—kHz

fV —.— Hz

Port ^ -0-

Error

fH 119.0kHz

fV 190.0 Hz

Port ^ -O-

No signal (the computer is not connected,

the mains power to the computer is

disconnected or the input connector in

use may be deselected, see Page 13

Signal for instructions.)

The horizontal or vertical sync, signal are

outside of the permitted range (the value of

the horizontal sync, signal will be displayed

in red and the value of the vertical sync,

signal will be displayed in white.)

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 49 50

Sin comentarios

Panasonic PANASYNC/PRO TX-D1F64 Manual de usuario Pagina 14