
Viewing 3D images
36
Disposal
A lithium-ion polymer rechargeable battery is built in to the 3D Eyewear. Please discard according to local regulations.
When disposing this 3D Eyewear, disassemble properly by following the procedure below, and remove
the internal rechargeable battery.
Do not disassemble this 3D Eyewear except when disposing of it.
Danger
As the rechargeable battery is specifically for this 3D Eyewear, do not use it for any other device.
•
Do not charge the removed battery.
•
Do not throw the battery in a fire, or apply heat to it.
•
Do not pierce the battery with a nail, subject it to an impact, or dismantle or modify it.
•
Do not let the wires touch any other metal or each other.
•
Do not carry or store the battery with a necklace, hair pin, or the like.
•
Do not charge, use, or leave the battery in a hot location such as near a fire or under the hot sun.
Doing so may cause the battery to generate heat, ignite, or rupture.
Warning
Do not place the removed battery, screws, and other items within reach of infants.
Accidental swallowing of such an item may have an adverse effect on the body.
•
In the event that you think such an item has been swallowed, consult a doctor immediately.
In the event of fluid leaking from the battery, take the following measure, and do not touch the
fluid with bare hands.
Fluid entering into an eye may cause loss of eyesight.
•
Wash the eye with water immediately without rubbing it, and then consult a doctor.
Fluid getting on your body or clothes may cause inflammation of the skin or injury.
•
Sufficiently rinse with clean water, and then consult a doctor.
■ How to remove the battery
Disassemble this 3D Eyewear after the battery has run out of power.
The following figures are intended to explain how to dispose of the 3D Eyewear, not for
describing how to repair. The 3D Eyewear cannot be repaired once it has been disassembled.
1 Fold the part of the
frame without the
power switch, and
then remove the two
screws on the inside
of the hinge with a
precision Phillips
(plus + ) screwdriver.
Screws
Frame
2 Bend the frame
inwards and pull it off
from the side cover.
•
If it is difficult to
remove, insert a
flat-blade (minus - )
screwdriver and
force it off.
Side cover
Battery
3 Remove the battery
from inside the side
cover, and cut the two
wires one by one with
scissors.
•
Insulate the wire parts
of the removed battery
with cellophane tape.
Note
•
Take sufficient care when performing this work so
as not to injure yourself.
•
Do not damage or dismantle the battery.
To view the 3D images
You can enjoy the 3D images in a variety of ways.
(Frame Sequential, Side by Side and Top and Bottom are the supported 3D format.)
■ Playing back 3D-compatible Blu-ray disc (Frame Sequential format)
•
Connect the 3D-compatible player via a fully wired HDMI compliant cable.
•
If input mode is not switched automatically, select the input mode connected to the player. (p. 31)
•
If you use the non 3D-compatible player, the images will be displayed on 2D mode.
■ 3D-supported broadcast
•
Please consult the suppliers of contents or programmes for availability of this service.
Comentarios a estos manuales