Panasonic TH65PZ700B Instrucciones de operaciones Pagina 51

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 56
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 50
FAQs, etc.
51
Problem Actions
Frequently Asked Questions
Screen Sound DVB
Due to the digital reception technologies involved, quality of the DTV signals may be relatively low in
some cases, despite good reception of analogue programmes.
Chaotic image, noisy
Set “P-NR” in the Picture Menu (to remove noise). (p. 22)
Check nearby electrical products
(car, motorcycle, fluorescent lamp).
The remote control
does not work
Are the batteries installed correctly? (p. 6)
Has the TV been switched On?
TV goes into
“Standby mode”
Off Timer function is activated.
The TV enters “Standby mode” about 30 min. after analogue
broadcasting ends.
Unusual image is displayed
Turn off the TV with Mains power On / Off switch, then turn it on
again.
Pictures from external
equipment are unusual
when the equipment is
connected via HDMI
Is the HDMI cable connected properly? (p. 44)
Turn Off the TV and equipment, then turn them On again.
Check an input signal from the equipment. (p. 49)
Use an equipment compliant with EIA/CEA-861/861B.
Sound is unusual
Set the sound setting of the connected equipment to
“2ch L.PCM”.
Check the “HDMI1 / 3 Input” setting in the Sound Men
u. (p. 22)
If digital sound connection has a problem, select analogue
sound connection. (p. 41)
Interference or
frozen / disappearing
image in DVB
Check “DVB Signal Condition”. (p. 31)
If “Signal Quality” or “Signal Strength” are displayed in red,
check aerial.
If problem persists, consult your local Panasonic dealer.
Turn the TV off with the Mains power On / Off switch, then turn
it On again.
Sound level is low
or sound is distorted
Sound signal reception may be deteriorated.
Set “NICAM” (p. 22) in the Sound Menu to “Off”.
(Analogue only)
No sound is produced
Is “Sound mute” active? (p. 7)
Is the volume set to the minimum?
Blurry or distorted image
(no sound or low volume)
Reset channels. (p. 30)
No image can be
displayed
Is “Colour” or “Contrast” in the Picture Menu set to the minimum?
(p. 22)
HDMI Other
An error message appears
Follow the message’s instructions.
If the problem persists, contact the authorized Service Centre.
Whirling sound is heard
The sound is from built-in cooling fan
(not a sign of faulty operation).
“VIERA Link” function
does not work and an error
message appears
Confirm the connection.
Turn the connected equipment on and then switch the TV on.
(p. 42)
Vista de pagina 50
1 2 ... 46 47 48 49 50 51 52 53 54 55 56

Comentarios a estos manuales

Sin comentarios