
Setting a Disc
7 Open the disc tray
Press the eject button and slowly pull out the tray
2 Place a disc
Place the disc with the label facing upward in the
drive and push down until the center holder clicks
<Removing a diso
Place a finger on the center holder and lift up on the
edge of the disc
3 Close the disc tray
Close the tray without touching the eject button
Label side up
• Do not apply excessive force to the tray in the open position, doing so could damage
the tray I
• <Using PC Cards> '
If the PC Card does not work, tliere may be no interrupt request (IRQ) line available j
Deactivate unnecessary equipment using m the Setup Utility J
/<note>
References to “CD" in the Setup Utility will not change when the CD-R/RW Drive
Pack IS installed
If the vibration of the CD-R/RW drive is excessively high, set [CD Drive Speed] m
the Setup Utility to [Low]
Comentarios a estos manuales