Panasonic VLG201CE Manual de servicio descargar pdf (Pagina 32)

Using the Unit

{PUSH} mode (Push to talk mode)

1 When a ringer tone is heard, press {TALK}.

2 Speak to the visitor.

3 To end the conversation, press {TALK}.

L The display will turn off.

{AUTO} mode (Auto talk mode)

This mode allows you to answer the call by voice. Speak a brief reply into (or toward) the

monitor station, such as “Yes?” or “Hello?”. This reply is used to start {AUTO} mode; the

visitor will not hear your reply. The monitor station will beep to indicate {AUTO} mode has

started and you may then speak to the visitor.

1 When a ringer tone is heard, answer “Yes?” within 30 seconds.

L A beep will sound to indicate that you can talk to the visitor (hands-free conversation).

2 Speak to the visitor.

3 To end the conversation, press {TALK}.

Note:

L Make sure you are within about 50 cm of the monitor station.

L You can also answer the call by pressing {TALK}.

L Your initial reply should be brief (less than 1 second), otherwise {AUTO} mode will not start.

L If a visitor calls you, a loud, brief sound (such as a barking dog) may start {AUTO} mode

even though you have not replied by voice.

{HOLD} mode (Hold to talk mode)

1 When a ringer tone is heard, press and hold {TALK} to speak to the caller.

L A beep will sound and the Talking indicator will light.

2 To listen to the visitor, release {TALK}.

L The Talking indicator will turn off.

3 To speak again, press and hold {TALK}.

4 To end the conversation, tap {TALK}.

Note:

L Make sure you speak to the caller only while pressing {TALK} and release {TALK} when

you have stopped speaking so that the caller can speak to you.

G201CE(E).book Page 32 Friday, November 11, 2005 4:46 PM

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 38 39 40

Sin comentarios

Panasonic VLG201CE Manual de servicio Pagina 32