Panasonic CF-T1 Manual de usuario descargar pdf (Pagina 68)

Dealing with Problems (Summary)

●Battery Indicator

●Keyboard

●Network

The red indicator lights

●The battery level is low. Save your data and power off your computer.

After connecting the AC adaptor or replacing the battery pack with a fully charged

one, turn your computer on.

The red indicator blinks

●The battery pack or recharging function may be defective. Quickly save current data

and exit Windows. Remove the battery pack and disconnect the AC adaptor, then

connect them again.

If the problem persists, contact your technical support office.

The orange indicator blinks

●Unable to recharge due to violation of temperature limits. The ambient temperature

is outside the allowable range. Once the allowable range requirement is satisfied,

charging begins automatically.

Only numbers can be inputted

●Check whether the indicator is on. If it is on, the computer is in ten-key keyboard

mode. To disable the ten-key mode, press

NumLk

Only capital letters are being

input

●Check whether the indicator is on. If it is on, the computer is in Caps Lock mode.

To disable the Caps Lock mode, press

Caps Lock

How to input European

characters (

ß,à,ç), symbols or

Euro Currency Symbol is

unclear

●Windows 2000

Select [Start] - [Programs] - [Accessories] - [System Tools] - [Character Map].

The Character Map will be displayed. Point to the desired font name and select it.

Windows XP

Select [start] - [All Programs] - [Accessories] - [System Tools] - [Character Map].

The Character Map will be displayed. Point to the desired font name and select it.

Windows 2000

Windows 2000Windows 2000

Windows 2000

After resuming, input keys do

not work properly

●When the computer enters standby or hibernation mode while

Alt

Ctrl

Shift

are held down, these keys may remain in “pressed” mode when the computer

resumes operation. Pressing these keys once will return the keys to normal.

Unable to connect to a network

●Confirm that either [Modem] or [LAN] is set to [Enable] in the Setup Utility.

●When using the computer as a network computer, some additional settings may

have to be made depending on the usage conditions. We recommend asking your

system administrator or the person in charge of the network.

●If the standby or hibernation mode is entered, the computer may have to be

restarted.

●Are the I/O address, interrupt levels, and memory address set correctly?

Also, check whether these settings for network are competing with other peripheral

devices.

●If the link lamp on the HUB unit is not on and the network cannot be accessed, set

the speed to match the HUB unit. (

 page 52)

Windows 2000

Windows 2000Windows 2000

Windows 2000

When performing a copy

operation via a LAN card with a

computer on the network, an

error message is displayed and

the copy operation fails

●The settings for the LAN card you are using may not be optimized. Confirm this with

the following procedure.

1 Select the network card you are using from [Network adapters] in [Control

Panel] - [System] - [Hardware] - [Device Manager].

2 Select [Advanced], select [Store And Forward] from [Property], then set

[Enable] for [Value] if it is set to [Disable].

(This item may be unavailable for some types of network cards.)

●Confirm that the computer on the network is operating properly and that the file is

not corrupt.

1 2 ... 63 64 65 66 67 68 69 70 71 72

Comentarios a estos manuales

Sin comentarios

Panasonic CF-T1 Manual de usuario Pagina 68

Comentarios a estos manuales

Relacionado con productos y manuales para Ordenadores Panasonic CF-T1