Panasonic NVVS40B Instrucciones de operaciones Pagina 7

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 80
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 6
Basic Operations
7
Remarks, etc.
Always set the [CAMERA/OFF/VCR] Switch to [OFF]
before disconnecting the AC Mains Lead.
If you use the Movie Camera for a long time, it
becomes warm. However, this is normal.
Do not use the AC Adaptor for any purposes other
than supplying the unit with power or charging the
Battery.
When not using the AC Adaptor, unplug its AC Mains
Lead from the AC mains socket. To unplug, pull it by
the plug, not by the lead.
This AC Adaptor works on any mains supply voltage
between 100 and 240 V, and any frequency between
50 and 60 Hz. For use in other countries, an adaptor
plug may be necessary.
Before connecting the DC Input Lead to the Movie
Camera, be sure to set the [CAMERA/OFF/VCR]
Switch to [OFF].
After use, be sure to disconnect the Car Battery
Charger from the cigarette lighter socket.
The Car Battery Charger can be used with 12 V and
24 V DC negative-grounded vehicles.
Do not start the car engine while the Movie Camera is
being powered by the car battery.
If the voltage drops suddenly e.g. because the car
air-conditioner is turned on, the Movie Camera is
automatically turned off to protect it.
Wait about 10 seconds before turning it on again.
If the Car Battery Charger is already connected to the
cigarette lighter socket when you start the engine, the
fuse in the Car Battery Chargers plug may blow.
Also read the operating instructions of the Car Battery
Charger.
Connect the other end
of the DC Input Lead
to the AC Adaptor.
Connect the AC
Mains Lead to an
AC mains socket.
Connect the AC
Mains Lead to
the AC Adaptor.
Car Battery Charger
The AC Mains Leads outlet plug cannot be
pushed fully into the AC Adaptor socket. A gap
will remain as shown below.
Vista de pagina 6
1 2 3 4 5 6 7 8 9 10 11 12 ... 79 80

Comentarios a estos manuales

Sin comentarios