Panasonic PVGS400 Instrucciones de operaciones descargar pdf (Pagina 16)

Before Use

16

ª Using the Remote Controller

1 Direct the Remote Controller at the Remote

Control Sensor

(36) of the Camcorder and

press an appropriate button.

≥Distance from the Camcorder: Within

approximately 15 feet (5 meters)

≥Angle: Within approximately 10o in the

upward, and 15o in the downward and

horizontal directions from the central axis

≥The above operating ranges are for indoor use.

Outdoors or under strong light, the Camcorder

may not operate properly even within the above

ranges.

≥Within a 3 feet (1 meter) range, you can also

use the Remote Controller on the LCD Monitor

side of the Camcorder.

Selecting Remote Controller Modes

When 2 Camcorders are used simultaneously,

they can be operated individually by selecting

different Remote Controller Modes.

≥If the Remote Controller Mode of the Camcorder

and that of the Remote Controller do not match,

[REMOTE] Indication is displayed.

Setup on the Camcorder:

Set [REMOTE] on the [INITIAL] Sub-Menu to the

desired Remote Controller Mode. (

-23-, -24-, -25-)

Setup on the Remote Controller:

[VCR1]: Press the [D] Button and [∫] Button

simultaneously. 1

[VCR2]: Press the [E] Button and [∫] Button

simultaneously. 2

≥When the battery in the Remote Controller is

replaced, the mode is automatically reset to

[VCR1] Mode.

10˚

15˚

15˚

15˚

(36)

INDEX INDEX

SELECT

STOP

KL

∫

STILL ADV

W

PAU SE

STILL ADV

61 5

;

ED

P.B. ZOOM

21

Power Supply

ª Using the AC Adaptor

1 Connect the DC Cable to the Camcorder.

2 Connect the DC Cable to the AC Adaptor.

3 Connect the AC Cable to the AC Adaptor

and the AC Jack.

≥The AC Cable’s outlet plug does not fit

entirely into the AC Adaptor jack. A gap will

remain as shown 1.

≥Before connecting or disconnecting the

power supply, set the [OFF/ON] Switch on

the Camcorder to [OFF] and make sure that

[POWER] Lamp is not lit.

ª Using the Battery

Before use, fully charge the Battery.

≥We recommend using a Panasonic Battery.

≥We cannot guarantee the quality of this

Camcorder when batteries from other

companies are used.

1 Attach the Battery to the AC Adaptor and

charge it.

≥Since the Battery will not be charged when

the DC Cable is connected to the AC

Adaptor, disconnect it from the AC Adaptor.

≥The [CHARGE] Lamp lights up, and charging

starts.

≥When the [CHARGE] Lamp goes off,

charging is completed.

≥When the battery is completely discharged,

the [CHARGE] lamp blinks at first, but the

battery is charged normally. When the

temperature of the battery is too high or low,

the [CHARGE] lamp blinks and the charging

time becomes longer than usual.

1

PV-GS400Eng.book 16 ページ２００４年６月４日　金曜日　午後３時１７分

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 205 206

Comentarios a estos manuales

Sin comentarios