
Record mode
57
LSQT0945
Check the recording
The last image recorded is played back for 2 to
3 seconds. After checking, the camera will be set
to a recording pause.
≥Set to Tape Recording Mode.
1 Press the joystick during the recording
pause until the icon 1 appears.
2 Move the joystick down to select the
recording check icon [ ].
Blank search function
Searches for the last part of the image recorded
(unused part of the tape).
≥Set to Tape Recording Mode.
1 Set [BASIC] >> [BLANK SEARCH] >> [YES].
ª
Stopping blank search midway
through
Move the joystick down.
≥If the cassette tape has no blank part, then the
camera will stop at the end of the tape.
≥The camera stops at a point approx. 1 second
before the end of the last image recorded.
When you start recording at that point, the
image can be recorded seamlessly from the last
image.
Zoom in/out function
You can zoom in up to 20k optically.
≥Set to Tape Recording Mode.
1 Wide-angle recording (zoom out):
Push the [W/T] lever towards [W].
Close-up recording (zoom in):
Push the [W/T] lever towards [T].
≥When zooming in and taking a picture while
holding the movie camera by hand, we
recommend using the image stabilizer function.
≥When you are zooming on a faraway subject, a
sharper focus is achieved if the recording
subject is 1.2 metres or further from the movie
camera.
≥When the zoom speed is high, the subject may
not be focused easily.
≥When the zoom magnification is 1k, the movie
camera can focus on a subject approx. 2 cm
distant from the lens.
ª
Digital zoom function
If the zoom magnification exceeds 20 times , then
the digital zoom function will be activated. The
digital zoom function allows you to select a
magnification from 50k to 800k.
1 Set [ADVANCE] >> [D.ZOOM] >> [50k] or
[800k].
[OFF]: Optical zoom only (Up to 20k)
[50k]: Up to 50k
[800k]: Up to 800k
≥The larger the digital zoom magnification, the
more the image quality is degraded.
1
VOL
WT
1tW
12tW
20tW
T
T
T
50tW
T
GS6GC_ENG.book 57 ページ 2005年3月1日 火曜日 午後1時40分
Comentarios a estos manuales