
85
VQT1T39
Advanced (Recording pictures)
∫ Setting up [ ] (AF Tracking)
Note
•
If it fails to lock, AF area will flash in red, and disappear. Try to lock again.
• AF Tracking will not operate when the subject is not specified, the subject is lost, or has failed
to be tracked. The picture will be taken with [
Ø] in [AF MODE] in that case.
• It is not possible to set [ ] in [STARRY SKY], [FIREWORKS], [PIN HOLE] or [FILM GRAIN] in
scene mode, or in the motion picture mode.
• [ ] does not work in AF tracking.
• The focus range becomes the same as AF macro mode. [1 cm (0.04 feet) (Wide)/30 cm
(0.99 feet) (Tele) to ¶]
• Dynamic tracking function may not work in the following cases:
– When the subject is too small
– When the recording location is too dark or bright
– When the subject is moving too fast
– When the background has the same or similar colour to the subject.
– When jitter is occurring
– When using the zoom
∫ About AF area selection
You can select the AF area by pressing [FOCUS] when [ ], [ƒ], [Ø] or [Ù] is
selected.
It is also possible to switch to AF area selection screen by pressing 1 when AF mode is
selected with 3/4.
•
You can set from the quick menu. (P25)
When selecting [ƒ], [Ø] or [Ù]
1 Press 3/4/2/1 to move the AF area.
•
You can set to arbitrary position of the screen.
(It cannot be set to edge of the screen)
• After moving the AF area, press [DISPLAY] to
return it to the centre.
2 Press [MENU/SET] to set.
When selecting [ ]
1 Press 3/4/2/1 to select AF area as
shown in the figure to the right.
2 Press [MENU/SET] to set.
1 Bring the subject to the AF tracking
frame, and press [AF/AE LOCK] to lock
the subject.
•
AF area will continuously focus on the
subject's movement once the subject is
recognised. (Dynamic tracking)
• AF tracking is turned off when [AF/AE
LOCK] is pressed again.
Before locking Locked
2 Take the picture.
M
EB-DMC-LX3_eng.book 85 ページ 2008年7月14日 月曜日 午後7時38分
Comentarios a estos manuales