Panasonic KXTCD340E Instrucciones de operaciones Pagina 35

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 76
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 34
Base Unit Settings
35
Helpline Tel. No.: U.K. 08700 100 076 R.O.I. 01289 8333
Ringer setup
Night mode
Night mode allows you to select a block of
time during which the base unit will not ring
for outside calls. This feature is useful for
times when you do not want to be disturbed,
for example, while sleeping. Night mode can
be set independently for the handset (page
29) and the base unit.
Set the date and time beforehand (page 15).
Note:
L To avoid disturbances, we recommend
turning the call screening feature off (page
57) in addition to turning the night mode
feature on.
Setting the start and end time for night
mode
1 Press $ (middle soft key).
2 Select Z, then press ,.
3 Enter 0000 (default base unit PIN).
L If you changed the PIN, enter it (page
37).
4 Select Ringer Setup, then press
,.
5 Select Night Mode, then press
,.
6 Select Start/End, then press ,.
7 Enter the desired hour and minute you
wish to start this feature by selecting 2
digits for each.
L If you use 12-hour time entry, select
AM or PM by pressing {*}
repeatedly before entering the time.
8 Enter the desired hour and minute you
wish to end this feature by selecting 2
digits for each.
L If you use 12-hour time entry, select
AM or PM by pressing {*}
repeatedly before entering the time.
9 Press ,.
10 Press {ih}.
Turning night mode on/off
1 Press $ (middle soft key).
2 Select Z, then press ,.
3 Enter 0000 (default base unit PIN).
L If you changed the PIN, enter it (page
37).
4 Select Ringer Setup, then press
,.
5 Select Night Mode, then press
,.
6 Select On/Off, then press ,.
7 Select On or Off, then press ,.
8 Press {ih}.
Setting the ring delay for night mode
This setting allows the base unit to ring
during night mode if the caller waits long
enough. After the selected amount of time
passes, the base unit will ring. If you select
No Ringing, the base unit will not ring
during night mode.
1 Press $ (middle soft key).
2 Select Z, then press ,.
3 Enter 0000 (default base unit PIN).
L If you changed the PIN, enter it (page
37).
4 Select Ringer Setup, then press
,.
5 Select Night Mode, then press
,.
6 Select Ring Delay, then press
,.
7 Select the desired setting, then press
,.
8 Press {ih}.
Note:
L When the answering system answers the
call, this feature does not work.
TCD340E(e).book Page 35 Thursday, June 9, 2005 9:50 AM
Vista de pagina 34
1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 75 76

Comentarios a estos manuales

Sin comentarios